Save and reboot, the MCD will now operate correctly. REM out the 'IF Errorlevel 1 Goto END' line. If you do, you need to edit the autoexec.bat file on the boot disk as follows. If you have version 701 of the Master CD and the old 200 version of the Boot Floppy, you may have a problem remastering - getting an incorrect CD version. To resolve this problem order the following replacement media: This is a problem with the some of the original Master CDs, and Boot Floppy Diskettes. This came up when remastering a Club 40 during the "Copying files" phase. If you run this program and put a floppy disk into the disk drive, it will format the disk, and create a new Master CD boot disk for you. In the C:\DRIVERS\MCDBF folder there is a file called either MKMCDBF.BAT or MKMCDFD.BAT. Once completed, it returns you to previous menu.ģ. This option runs FDISK, reboots and then formats the hard drive. Reinitialize Hard Drive - No further warnings are given. This will take some time." Only the operating system is reinstalled. The Hard Drive is formatted, with the message "Please be patient. Advanced Feature - Gives you 4 other options, The computer will restart automatically several times before eventually getting to the User information section.Ģ. When this is finished, the computer will restart and go on to "Preinstalling Software.". The computer will go into setting up and detecting hardware followed by the standard win 98 first time setup. On completion, you will be asked to remove the floppy disk and press any key to restart the computer. When ready, you will be asked to insert Master CD 2 and press any key to continue. If the CD ROM draw is opened - it will show a Device Error (R)etry, (F)ail? As long as the progress bar is moving and the hard drive light is flashing, remastering is progressing OK. It will also say "Copying Files to Hard Drive. The screen will then show an Orange progress bar moving up and down. There is no warning! This only takes a minute. Normal - Choosing this option launches straight into FORMATTING the HARD DRIVE. When you run the Master CD, you will be presented with 3 options,ġ. Go into the Display Properties, click on Settings, and Advanced Properties, then Adapter, and change the Refresh Rate to 85Hz and all will be well. 
It turns out that these monitors seem to like to have the graphics card set to 85Hz (when used in conjunction with the SiS adapter), otherwise the display will look a little wonky. On the Packard Bell Club machines with the SiS 5597/5598 graphics card and the 2025E monitors, sometimes the display goes "blurred and fuzzy", though it looks normal in Safe Mode. Packard Bell Club Series Blurred Display with 2025E Monitor
0 kommentar(er)
